Maytag washer mvwb765w.
Maytag washer not filling up with water.
If the washer stops filling then the problem is related to the electrical circuit that controls the.
Learn about the reasons why your washer won t fill with water.
There may be a bad wire connection on the water inlet valve or a bad solenoid valve that is not letting water into your washing machine rr.
A maytag top load washer fails to fill with water for a variety of reasons including closed water valves kinked hoses and dirty valve screens according to the manufacturer.
You may notice during a cycle that the wash load is not completely submerged in water.
If the water inlet valve is defective the wash may fill slowly or not fill at all.
All of these problems are easy to troubleshoot without professional help.
To verify that the valve is at fault unplug the washer when the symptom occurs.
If the washer continues to fill then the water inlet valve is defective.
If your washer continues to fill during a cycle the water inlet valve could be at fault.
The water inlet valve requires sufficient water pressure to function properly.
Before proceeding you have to make sure that the washer is unplugged in order to eliminate the risk of electric shock.
Next inspect your hoses for crimps or kinks.
If water is getting to the washer but will not fill with water then check the water inlet fill valve where the water supply hoses screw onto the washer.
If your washer if not filling start by making sure the faucet at the water supply end of the hose is turned on.
Will not fill with water.
Maytag washer fills slowly or will not fill at all.
If the water level seems too low or if the washer does not fill completely auto sensing helps stabilize the amount of water used.
Control board was tested and it too is not the problem.
If so make sure the water supply hoses are not bent.
They re about four or five feet long and attach to the back of the machine at the water inlet valve.
Fixing the washing machine is simple with our diy repair help and videos.
The washer senses the size of the load and adds the correct amount of water for the load size.
No valve blockage and electric valves open and close when bench tested.
01 water inlet valve.
Find information on common parts that may be worn out or broken like the water inlet valve the lid switch and the selector switch.
The water inlet valve opens to allow water to enter the washing machine.
To test this you ll need to open up the washer and locate the control panel.
The reason the washing machine won t fill might lie with the water level switch.
