I turned the water off at the wall.
Maytag neptune washer hot water valve.
California 19410 business ctr dr.
Using this on our 10 year old maytag neptune front loading wash machine.
You will need to check the hot water valve the door lock latch the cold water valve the hose clamp and the drain pump.
Cleveland tn 37311 1 877 477 7278.
The power went off the other day and i heard water dripping into the washer.
Next remove the four wires and loosen up the clamp.
Our water pressure in our home is about 94 psi.
The water inlet valve requires a minimum of 20 psi to shut off properly.
New ap3267279 washer water inlet valve fits frigidaire.
Report this by hickslees hickslees.
One valve regulates the hot water and the other valve regulates the cold water.
A problem with the valve can cause the washer not to fill properly or not fill at all.
Whirlpool 22003834 water valve thermistor.
Check the water pressure to determine if it is sufficient.
If power is removed and the solenoid operated input water valve is questionable then it may leak.
There is little that you can do to repair the valve itself but you can clean the two inlet ports to restore full water flow.
The water flows into the tub from the upper rear section of the unit.
How do i replace the water inlet valve on a maytag neptune washer.
Watch this how to video with simple step by step instructions for a succe.
I can t figure out how to remove it so that i buy the correct replacement part.
If the washer will not fill with water there are some parts that you will need to check to see which one is causing the issue.
To gain access to the water valve locate the back of the washer and remove the hot and cold hoses as well as the whole assembly.
For most washers water enters the unit from two valves on the rear of the appliance we have a few models that only have one inlet valve.
If cold water does not flow into washer or the washing machine will not fill with hot water replacing the valve can be the solution.
Genuine maytag neptune washer water inlet valve 22002795 wp22002795.
Northridge ca 91324 1 877 477 7278 tennessee 240 edwards st.
Free shipping on many items.
The water inlet valve on your washing machine is the part that connects the two water hoses to the machine and it controls the flow of both hot and cold water.
If the water inlet valve does not get enough pressure the valve may not close fully after the power is shut off.
We hope this helps.
Hi george thank you for your question.
As a result water can leak into the washer and cause it to overflow.
